ENGLISH
Set up speakers (Audyssey® Auto Setup)
About setup microphone placement
•Measurements are performed by placing the setup microphone successively at multiple positions throughout the entire listening area, as shown in GExample qH. For best results, we recommend you measure in six positions, as shown in the illustration (up to six positions).
•Even if the listening environment is small as shown in GExample wH, measuring at multiple points throughout the listening environment results in more effective correction.
1 | Prepare the setup microphone |
|
Mount the setup microphone on a tripod or stand and place it in the main listening position.
When placing the setup microphone, adjust the height of the sound receptor to the level of the listener’s ear.
Sound receptor
Setup microphone
2 | Set up the subwoofer |
If using a subwoofer capable of the following adjustments, set up the subwoofer as shown below.
nn When using a subwoofer with a direct mode
Set the direct mode to “On” and disable the volume adjustment and crossover frequency setting.
nn When using a subwoofer without a direct mode
Make the following settings:
• Volume : “12 o’clock position” |
| GExample qH | |
| FL SW C | FR |
( | : Measuring positions) | |
SL | *M | SR |
|
| |
| SBL | SBR |
GExample wH
FL SW C | FR |
( : Measuring positions)
SL | *M | SR |
| ||
SBL |
| SBR |
NOTE
• Do not hold the setup microphone in your hand during |
• Crossover frequency : “Maximum/Highest Frequency” |
• Low pass filter : “Off” |
• Standby mode : “Off” |
NOTE
When you use two subwoofers, please adjust the subwoofer volume controls individually so that each subwoofer level is as close as possible to 75 dB using the test tone (vpage 63) before Audyssey Auto Setup.
3 Set up the remote control unit
nn Set up the operation mode
FL | Front speaker (L) | SL | Surround speaker (L) |
FR | Front speaker (R) | SR | Surround speaker (R) |
C | Center speaker | SBL Surround back speaker (L) | |
SW Subwoofer | SBR Surround back speaker (R) |
measurements. |
• Avoid placing the setup microphone close to a seat back or wall as |
sound reflections may give inaccurate results.
Press AMP to set the remote control unit to amplifier operation mode.
About the main listening position (*M)
The main listening position is the position where listeners would normally sit or where one would normally sit alone within the listening environment. Before starting Audyssey Auto Setup, place the setup microphone in the main listening position. Audyssey MultEQ® uses the measurements from this position to calculate speaker distance, level, polarity, and the optimum crossover value for the subwoofer.
Press AMP
8
The “Simple version” section provides the speaker installation, connection, and setup methods for the
For the installing, connecting, and setup methods of speakers other than the