Marantz SR6005 manual Finish, Calculation Check Store, Nn When turning Dynamic Volume on

ENGLISH

Set up speakers (Audyssey® Auto Setup)

STEP 4	STEP 5	STEP 6	Finish
Calculation	Check	Store

11On the STEP3 screen, use ui to select “Next 1 Calculation”, and then press ENTER.

Measuring results are analyzed, and the frequency response of each speaker in the listening room is determined.

AUTO SETUP
AUDYSSEY AUTO SETUP	MultEQ

STEP4 Calculation	[4/6]
Now calculating...
Please wait.
25%

•Analysis takes several minutes to complete. The time required for this analysis depends on the number of speakers connected.

The more connected speakers there are, the longer it takes to perform analysis.

12Use ui to select the item you want to check, and then press ENTER.

AUTO SETUP
AUDYSSEY AUTO SETUP	MultEQ

STEP5 Check	[5/6]
Check processing res-
ults. To proceed,press
“Next”
Spkr Config Check
Distance Check
Ch. Level Check
Crossover Check
Next Store
ENTER Enter		RETURN Cancel
Select item to check

•Subwoofers may measure a greater reported distance than the actual distance due to added electrical delay common in subwoofers.

•If you want to check another item, press

RETURN.

13Use ui to select “Next 1 Store” and then press ENTER.

NOTE

•If the result differs from the actual connection status, or if “Caution!” is displayed, see “Error messages” (vpage 11). Then carry out Audyssey Auto Setup again.

•If the result still differs from the actual connection status after remeasurement or the error message still appears, it is possible that the speakers are not connected properly. Turn this unit off, check the speaker connections and repeat the measurement process from the beginning.

•If you change speaker positions or orientation, perform Audyssey Auto Setup again to find the optimal equalizer settings.

14Select “Store” and then press ENTER. Save the measurement results.

AUTO SETUP
AUDYSSEY AUTO SETUP	MultEQ

STEP6 Store	[6/6]
Press “Store” to store
calculation results.
Store
ENTER Enter	RETURN Cancel
Apply and store measurement result

AUTO SETUP
AUDYSSEY AUTO SETUP	MultEQ

STEP6 Store	[6/6]
Now storing...
Please wait.
25%

•Saving the results requires about 10 seconds.

•If the measuring results are not to be saved, press RETURN. A message “Cancel Auto Setup?” will be displayed. Press o then select “Yes”. All the measured Audyssey Auto Setup data will be erased.

NOTE

During saving of measurement results, be sure not to turn off the power.

15Unplug the setup microphone from the unit’s SETUP MIC jack.

16Set Dynamic Volume®.

AUTO SETUP
AUDYSSEY AUTO SETUP	MultEQ

Finish	[6/6]
Storing complete.
Auto Setup is now
finished. Please unplug
microphone.
Turn on Dynamic Volume?
Yes	No

ENTER Exit

Turn Dynamic Volume on and exit Auto Setup

•For details of Dynamic Volume settings, see page 58.

nn When turning Dynamic Volume on

Use o to select “Yes“, and then press ENTER.

• The unit automatically enters “Evening” mode.

nn When turning Dynamic Volume off

Use p to select “No“, and then press ENTER.

NOTE

After performing Audyssey Auto Setup, do not change the speaker connections or subwoofer volume. In event of a change, perform Audyssey Auto Setup again.

10

Remote control operation	Move the cursor	Confirm the setting	Return to previous menu
buttons	(Up/Down/Left/Right)