Marantz SR7008 appendix Tips, Want the volume not to become too loud by mistake, 226

Contents Connections Playback Settings Tips Appendix

Tips

I want the volume not to become too loud by mistake.

•Set the volume upper limit for “Volume Limit” in the menu beforehand. This prevents children or others from increasing the volume too much by mistake. You can set this for each zone (vpage 167, 204).

I want to keep the volume at the same level when I turn the power on.

•By default, the volume setting when power was previously set to standby is applied at next power on. To use a fixed volume level, set the volume level at power on for “Volume Limit” in the menu. You can set this for each zone (vpage 167, 204).

I want to have the subwoofer always output audio.

•Depending on the input signals and sound mode, the subwoofer may not output audio.

When “Subwoofer Mode” in the menu is set to “LFE+Main”, you can have the subwoofer always output audio (vpage 198).

I want to make human voices in the movies clearer.

•Use “Dialog Level” in the menu to adjust the level (vpage 161).

I want to keep bass and clarity during playback at a lower volume level.

•Set “Dynamic EQ” in the menu to “On”. This setting corrects the frequency characteristics to allow you to enjoy clear sound without the bass being lost even during playback at a lower volume level (vpage 168).

I want to automatically adjust the volume level difference in content such as TV and movies.

•Set “Dynamic Volume” in the menu. Volume level changes (between quiet scenes and loud scenes) in TV shows or movies are automatically adjusted to your desired level (vpage 169).

I want to set the optimized listening environment after changing the configuration/position of the speakers or changing a speaker to a new one.

•Perform Audyssey® Setup. This automatically makes the optimized speaker settings for the new listening environment (vpage 183).

			226
Front panel	Display	Rear panel		Remote	Index