Marantz SR7008 appendix Crossovers, 22Set the crossover frequency, 197

Contents Connections Playback Settings Tips Appendix

Crossovers

Set in accordance with the lower limit frequency of the base frequencies that can be played back through each speaker.

22Set the crossover frequency

40Hz / 60Hz / 80Hz (Default) / 90Hz / 100Hz / 110Hz / 120Hz / 150Hz / 200Hz / 250Hz

22Speaker Selection

Selects how to set the crossover frequency. See the speaker manual for information concerning speaker crossover frequency.

All (Default) : Sets the same crossover frequency for all speakers.

Individual : Selects the crossover points for each speaker individually.

%

•“Crossovers” can be set when the “Subwoofer Mode” (vpage 198) setting is “LFE+Main”, or when you have a speaker that is set to “Small”.

•The default crossover frequency is “80Hz”, which will work best with the widest variety of speakers. However, we recommend setting to a higher frequency that the crossover frequency when small speakers are used. For example, set to “250Hz” when the frequency range of the speakers is 250 Hz – 20 kHz.

•For speakers set to “Small”, low frequency content below the crossover frequency is attenuated to the speakers and the low bass content is then re-delivered to the subwoofer, or the front (L/R) speakers if they have been set to Large.

•The speakers that can be set when “Individual” is selected differ depending on to the “Subwoofer Mode” (vpage 198) setting.

•When “LFE” is selected, speakers set to “Small” at “Speaker Config.” (vpage 193) can be set. If the speakers are set to “Large”, “Full Band” is displayed and the setting cannot be made.

•When “LFE+Main” is selected, speakers can be set regardless of the “Speaker Config.” (vpage 193) setting.

			197
Front panel	Display	Rear panel		Remote	Index