7Controls
| 4 |
|
| |
|
|
|
| 1 Battery Indicator |
|
|
|
| When pressing the TEST key or when a signal is |
|
|
| ||
|
|
|
| transmitted, the indicator light will blink. If it only |
|
|
|
| lights up weakly, the battery needs to be |
|
|
|
| replaced. |
3 | 2 |
|
| 2 TEST key |
|
|
|
| |
| 1 |
|
| Used for setting the GB 10’s system and |
|
|
|
| transmission codes. Also used when the system is |
|
|
|
| being set up for the first time. |
|
|
|
| 3 Sensitivity switch |
| 5 |
|
| Sets the alarm threshold for response to breaking |
6glass. Position "1" is high sensitivity, "2" is low.
4 Battery compartment Insert 2 x 1,5 V batteries (AAA).
5 Microphone
This picks up and recognizes the typical frequency of breaking glass, and activates the alarm.
6 Dusk Sensor
Activates the Life style program in the SC 2200/2700 control unit when the
7 Antenna
A small plastic tube is supplied with the sensor. Place it over the wire aerial and press it into the holder on the top side of the GB 10.
Installation and
1 Inserting the batteries
Open the
Close the
Note: The code settings are maintained when replacing batteries. In case the sensor looses contact with the base console, the sensor has to be
2 Activating the GB 10
Open the
Press the TEST key for longer than one second. The red indicator light will flash twice.
3Registering the sensor with your security system
Set the mode switch on the security console to
INSTALL
Press the TEST button on the GB10 sensor Reset the mode switch to RUN1 or RUN2
4Setting the system address (light control/life style function)
Press and hold the TEST key unit, the indicator light will light continuously.
Press the TEST key the number of times that corresponds to the system address you are setting, e.g. 5 times for address "E", 12 times for address "L".
After 5 seconds the LED will flash the same number of times you pressed earlier.
MS9470/MS9770/MS9970 | 13 |