This access code, is your Personal identification code. When you have changed this code, you are the only person having access to the settings of the SC2800 base station. You can also use this code to arm and disarm the system via the keyboard of the base station. In case you loose your PIN, you have to contact your Marmitek Authorised Service Centre (MASC) to reset the access code to the factory default [0000].
Entering you PIN code.
Every time you press a key you hear a short confirmation beep.
1.Set the mode switch to the INSTALL position: All indicators of occupied zones come on
2.Key in your 4 digit PIN code (factory default [0000])
3.Press key number 7
4.Press ENTER
5.Enter your new access code (PIN)
6.Press ENTER
7.Enter your new access code again: One double confirmation beep
8.Reset the mode switch to the RUN 1 or RUN 2 position: Zone indicators go out
MS9470/MS9770/MS9970 | 21 |