7. SC2800 DIAL-IN FEATURES
Your SC2800 base station is equipped with a
1. SETTING THE PHONE LINE PICK UP TIME
You can set the time it takes for the base station to answer an incoming call. The factory default is 30 seconds. When you are using services like voice mail, an answering machine, etc., you may want to set the line pick up time shorter (15 sec). The
To set the phone line pick up time:
1.Set mode switch to INSTALL: All indicators of occupied zones come on
2.Enter your 4 digit PIN code (factory default [0000] refer to 5.8): One confirmation beep at every key press
3.Press key number 3: One short confirmation beep
4.Press ENTER: One short confirmation beep
5.You can now choose 1 of 3 options: Press 0 for a pick up time of 30 seconds Press 1 for a pick up time of 15 seconds
Press 2 for disabling the
6.Reset mode switch to RUN 1 or RUN 2 position: Zone indicators go out
2. ARMING AND DISARMING VIA THE TELEPHONE
As soon as the base station answers your call, you can arm or disarm the security system.
Arming and disarming the system:
1.Call the base station from a touch tone or mobile phone.
2.The base station will answer your call with 3 short beeps
3.After these beeps, enter your PIN code via the phone (factory default [0000] refer to 5.8).
4.The base station confirms a correct PIN code with 3 short confirmation beeps (an erratic PIN code is indicated by one long beep).
5.You now can select the ARM AWAY mode by entering 0 followed by a *. You’ll hear 3 short confirmation beeps.
6.You can disarm the system by entering 0 followed by a #. You’ll hear 2 short confirmation beeps.
3. SWITCHING LIGHTS OVER THE TELEPHONE
As soon as the base station answers your call, you can control lights and appliances with Marmitek
1.Call the base station from a touch tone or mobile phone.
2.The base station will answer your call with 3 short beeps.
3.After these beeps, enter your PIN code via the phone (factory default [0000] refer to 5.8).
4.The base station confirms a correct PIN code with 3 short confirmation beeps (an erratic PIN code is indicated by one long beep).
5.Switch ON lights or appliances connected to a module by entering it’s Unit Code (e.g. 12) followed by a *. You’ll hear 3 short confirmation beeps.
6.To switch OFF lights or appliances connected to a module, enter it’s Unit Code (e.g. 12) followed by a #. You’ll hear 2 short confirmation beeps.
30 | MARMITEK |