4.3 DS10 DOOR/WINDOW SENSORS
6
1
2
5
4.MAGNETIC CONTACTS (NOT SHOWN) The magnetic contacts are of the NC (Normally Closed) type. The distance between magnet and contact can not be more than 5mm. When mounted, you have to make sure that the arrows on magnet and contact line up. The length of wire between contact and sensor can be expanded or shortened. Make sure that the wires are well connected and the screws tightened. Multiple magnet switches can be placed in series.
5.BATTERY COMPARTMENT
For metal frames, the distance between contact and magnet can not be more than 3mm when door or window is in closed position. For wooden frames this distance is 8mm, but in all cases the opening should be kept to the minimum. To mount the transmitter part, you remove the batteries and screw the back of the transmitter onto a suitable background.
For
CONTROLS:
3
Place 2 pieces AA batteries observing the polarity instructions in the battery compartment. Use preferably alkaline batteries.
INSTALLATION (install mode):
clearly move away from each other.
Remove the protective cover of the
1.CONTROL INDICATOR When you press the button TEST, or when the unit is transmitting a signal to the base station, this
indicator will come on. When the indicator blinks only weakly, the batteries have to be replaced.
2.MIN/MAX
For setting a delay time of approx. 30 seconds. When switched to the MAX position, the delay time is activated. Position the DELAY switch behind the cover to the MIN position (instantaneous alarm). For an entrance door you set the switch to MAX, allowing you to enter and disarm the system When you want e.g. a garden door to respond immediately, you switch the DS10 to the MIN position.
3. TEST
Used for activating and installing the sensor during the installation procedure. Can also be used to test the sensor.
The Door/Window Sensor consists of a transmitter and a magnetic contact. The magnetic contact consists of 2 parts: the wired NC contact and a separate magnet. Normally the magnet will make the contact to close. When opening of a door or window, the contact be opened and a message will be sent to the base station (the red indicator will come on).
The DS10 is primarily meant for doors and windows, whereby the transmitter part and contact will be placed on the frame and the magnet on the moving part (door or window).
Look on door or window frame where the sensor can be positioned without running the risk of obstructing or damaging the sensor when opening this door or window. Position the sensor, if possible, as high up as possible. This will result in the best possible range. Then mark the position of the sensor and magnet contact. Do not place the magnet contact directly on a metal surface. In case of a metal or metal enforced plastic window- frame, it is recommended to use a 5mm wooden or plastic isolator between magnet contact and frame.
protective cover of the
N.B.: Make sure that the arrows on the contact and magnet line up.
After testing the system, it is recommended to also screw down the magnet on the surface.
6.MOUNTING THE ANTENNA OF EXTRA DOOR/WINDOW SENSORS
Extra door/window sensors are supplied with a wire antenna and a separate antenna tube. For proper operation, slide the plastic tube over the antenna wire and push it firmly into the sensor housing.
ACTIVATING THE DS10
Push the TEST key of the DS10 for more than 1 second; the indicator blinks twice. Then press the TEST key once more and close the battery cover.
N.B.: When replacing the batteries of the sensor when the system is operational, you can make sure that the sensor maintains its unique code avoiding
8 | MARMITEK |