CHIIMNEY INSTALLATION
INSTALLING “S” SERIES CHIMNEY SPACERS
To install the “S” series chimney sections, insert the male end of the flue (the smallest diameter pipe) into the flue outlet of the fireplace. Press down until the snap locks engage. Continue to add chimney sections on top of each other until chimney is at least 6" above roof opening on all sides. See Figure 19.
Note: As the chimney sections are installed, check each joint to make sure it is properly locked to the previous section.
Make outer pipe stronger by using two or three sheet metal screws placed through the area where the outer pipes overlap one another. Carefully drill a 1/8" diameter hole through the chimney sections. Do not drill into inner stainless steel flue pipe.
WARNING
Be very careful when drilling the holes into the outer pipe. Do not drill into inner stainless steel flue pipe.
S12
913/16"
259/16"
123/16"
S18
303/4"
2113/16"
S36
463/8"
2713/16"
S48
563/4" | S36 |
| S18 |
305/16"
611/16"
S36
S36
7611/16"
Note: Dimensions may vary slightly due to manufacturing tolerances.
Figure 19 - Chimney Sections for Elbow Offsets
395/16"
18 | 61D0008 |