INSTALLING GAS APPLIANCE
PASSING GAS LINE THROUGH FIREPLACE WALL
1.Locate recessed area in side brick side liner.
2.Lightly tap recessed area with a hammer until a round hole is tapped out. See Figure 37.
3.Remove the two (2) screws that hold cover plates on jacket wrap. Discard cover plate.
4.Install the gas pipe through the tube between the firebox and jacket.
5.Attach the gas appliance to the gas pipe according to the appli- ance makers instructions.
6.Pack insulation around the pipe to prevent air flowing through the tube either into or out of the firebox for proper seal.
Back Brick | Side Brick | |
Liner | ||
Liner | ||
| ||
| Hole | |
Figure 37 - Hole in Side Brick Liner | ||
WARNING
1.Turn gas off at the appliance.
2.Turn the gas on at the cut off valve.
3.Test the gas line connections for leaks with soapy water solution or a liquid leak detector. DO NOT USE A MATCH OR OTHER FLAME SOURCE TO CHECK FOR GAS LEAKS. If a gas leak is detected, turn the gas off immediately. Fix the leak.
7. Follow the instructions provided by the manufacturer for testing and adjusting gas line.
30 | 61D0008 |
