DS5001FP
23 of 26
NOTES:All parameters apply to both commercial and industrial temperature operation unless otherwise noted.
1) All voltages are referenced to ground.
2) Maximum operating ICC is measured with all output pins disconnected; XTAL1 driven with tCLKR,
tCLKF = 10ns, VIL = 0.5V; XTAL2 disconnected; RST = PORT0 = VCC, MSEL = VSS.
3) Idle mode, IIDLE, is measured with all output pins disconnected; XTAL1 driven with tCLKR,
tCLKF = 10ns, VIL = 0.5V; XTAL2 disconnected; PORT0 = VCC, RST = MSEL = VSS.
4) Stop mode, ISTOP, is measured with all output pins disconnected; PORT0 = VCC; XTAL2 not
connected; RST = MSEL = XTAL1 = VSS.
5) Pin capacitance is measured with a test frequency: 1MHz, TA = +25°C.
6) ICCO1 is the maximum average operating current that can be drawn from VCCO in normal operation.
7) ILI is the current drawn from VLI input when VCC = 0V and VCCO is disconnected.
8) VCCO2 is measured with VCC < VLI, and a maximum load of 10µA on VCCO.
9) Crystal startup time is the time required to get the mass of the crystal into vibrational motion from the
time that power is first applied to the circuit until the first clock pulse is produced by the on-chip
oscillator. The user should check with the crystal vendor for a worst-case specification on this time.
10) This parameter applies to industrial temperature operation.
11) PF pin operation is specified with VBAT ³ 3.0V.