High Performance Burner
(12,000 BTU*)
There is one high speed burner on your range, located in the right front position. This burner offers higher speed cooking that can be used to quickly bring water to a boil and for large- quantity cooking.
Drip Pans - Optional
Removeable porcelain covered drip pans are available for use with this appliance to help contain spills. Call 
Simmer Burner
This burner is located in the left rear position. The simmer burner offers a lower BTU* flame for delicate sauces or for melting chocolate.
* BTU ratings will vary when using LP gas.
Burner Grates
The grates must be properly positioned before cooking. Improper installation of the grates may result in chipping of the cooktop.
Do not operate the burners without a pan on the grate.
The grate’s porcelain finish may chip without a pan to absorb the heat from the burner flame.
Although the burner grates are durable, they will gradually lose their shine and/or discolor due to the high temperatures of the gas flame.
Oven Cooking
Manual Clean Oven Control
(select models)
Bake | Use for baking and roasting. |
Broil | Use for broiling and top browning. |
Timer | Sets Timer. |
Clock | Use to set |
CANCEL | Cancels all operations except Timer and Clock. |
More+ | Enters or changes time, oven |
or Less- | temperature. Sets HI or LO broil. |
|
|
Using the Touchpads
•Press the desired pad.
•Press the More+ or Less- pad to enter time or temperature.
Notes:
•A properly adjusted burner with clean ports will light within a few seconds. If using natural gas, the flame will be blue with a deeper blue inner cone.
If the burner flame is yellow or is noisy, the air/gas mixture may be incorrect. Contact a service technician to adjust. (Adjustments are not covered by the warranty.)
With LP gas, slight yellow tips on the flames are acceptable. This is normal and adjustment is not necessary.
•With some types of gas, you may hear a “popping” sound when the surface burner is turned off. This is a normal operating sound of the burner.
•If the control knob is turned very quickly from HI to LO, the flame may go out, particularly if the burner is cold. If this occurs, turn the knob to the OFF position, wait several seconds and relight the burner.
•The flame should be adjusted so it does not extend beyond the edge of the pan.
•A beep will sound each time a function pad is pressed. There is no beep for the More+ or Less- pad.
•A double beep will sound if a programming error occurs.
Important: Four seconds after pressing the More+ or Less- pad, the time or temperature will automatically be entered. If more than 30 seconds elapse between touching a function pad and the More+ or Less- pad, the function will be canceled and the display will return to the previous display.
Setting the Clock
1.Press the Clock pad.
•The clock time cannot be set if the control is programmed for a bake, broil or timing operation.
2.Set the correct time of day using the More+ or Less- pads. If the More+ or Less- pad is not pressed within 30 seconds, the program will cancel. Press the Clock pad and begin again.
11
