Leveling Legs
CAUTION
Be sure the
Be sure the range should be leveled when installed. If the range is not level, turn the leveling legs (located at each corner of the range) until range is level.
The
If an ungrounded,
Removal of Gas Appliance
Gas appliance connectors used to connect this appliance to the gas supply are not designed for continuous movement. Once installed, DO NOT repeatedly move this gas appliance for cleaning or to relocate. If this appliance has to be moved and/or removed for servicing, follow the procedure described
Oven Light
LEVELING LEG
in the installation instructions. For information, contact Maytag Customer Assistance at
To prevent range from accidentally tipping, range must be
CAUTION
•Disconnect power to range before replacing light bulb.
•Use a dry potholder to prevent possible harm to hands when replacing bulb.
•Be sure bulb is cool before touching bulb.
•Do not touch hot bulb with a damp cloth as this may cause the bulb to break.
To Replace Oven Light Bulb:
1.When oven is cool, hold bulb cover in place, then slide wire retainer off cover. Important Bulb cover will fall if not held in place while removing wire
retainer.
2. Remove bulb cover and light bulb.
3. Replace with a
WIRE
RETAINER
4.Replace bulb cover and secure with wire retainer.
5.Reconnect power to range. Reset clock.
Electrical Connection
Appliances which require electrical power are equipped with a three- prong grounding plug which must be plugged directly into a properly grounded
Always disconnect power to appliance before servicing.
secured to the floor by sliding rear leveling leg into the anti- tip bracket.
Storage Drawer (select models)
CAUTION
Do not store plastic, paper products, food or flammable materials in this drawer. The drawer may become too warm for these items when the oven is in use.
The storage drawer can be removed to allow you to clean under the range.
To remove:
1.Empty drawer and pull out to the first stop position.
2.Lift up the front of the drawer.
3.Pull out to the second stop position.
4.Grasp sides and lift drawer up and out.
To replace:
1.Fit the ends of the drawer glides into the rails in the range.
2.Lift up the front of the drawer and gently push in to the first stop position.
3.Lift drawer up again and push until drawer is closed.
Oven Bottom
Protect oven bottom against spillovers, especially acidic or sugary spills, as they may discolor the porcelain enamel. Use the correct pan size to avoid spillovers and boilovers.
8
