Maytag ACO1860AC Parts, Tools, and Materials, Following parts are supplied with the oven

Installation Instruction

Parts, Tools, and Materials

The following parts are supplied with the oven:

NOTE: Depending on ventilation requirements, not all parts will be used.

Backdraft damper / duct connector

(for roof-venting or wall-venting installation) Not Actual Size ( 2 pieces must be assembled as shown )

One power cord clamp and

One dark-colored mounting screw

(to hold the power cord) Actual Size

Two self - tapping screws

(for attaching the damper duct connector)

One lock pin and one washer-

One power cord clamp bushing -

(for the cord hole in a metal upper cabinet)

Four 1/4" x 2" lag screws -

(for wall stud holes)

Two 1/4" x 2" bolts -

(for securing to the upper cabinet)

Four 1/4" x 3" toggle bolts -

(for drywall holes)

Four spring toggle heads -

(for the toggle bolts)

Two washers -

(for the two upper cabinet bolts)

NOTE: Install at least two lag screws into one 2” X 4” stud and four anchor bolts into the wall. The mounting area must meet the 150 lbs. weight requirement.

Tools and materials required for installation:

List of tools include: Stud finder or thin nail, Saber saw, Keyhole saw, Electric drill, Phillips and Flat blade screwdriver, Pencil, Tape measure (metal), Plumb line, Tin snips, Caulking gun, Duct tape, Clear tape, Wood and Metal drill bits.

NOTE: Use the carton or heavy material for covering the counter top.

NOTE: Ductwork required for installation is not included. All wall and roof caps must have a back-draft damper.

16021668 Rev. 0 A–4 ©2002 Maytag Appliances Company