Installation Instruction
6.
damper |
NOTE: Damper/duct connector must be attached to microwave oven after microwave oven is installed.
7.Roof venting installation: Install ductwork through the vent opening in the upper cabinet. Complete the venting system through the roof according to the method needed. See, Preparing Venting System section. Use caulking to seal the exterior roof opening around the exhaust cap.
8.Use the power supply cord clamp to bundle the power supply cord. Install the power supply cord clamp inside the cabinet.
duct
power supply cord clamp
9.Grasp filter screen with one hand holding the ring and the other hand holding the opposite end. Insert the end of the filter screen without ring into the opening and slide towards the side of the microwave oven. Insert ring end of filter screen into the opening and slide entire screen towards the center of the microwave until screen is securely in position. Repeat for other filter screen.
10. Plug in the power supply cord.
©2002 Maytag Appliances Company | 16021668 Rev. 0 |