Maytag MAH9700AW* manual Display Diagnostic Codes, Go to Will Not, Drain, Go to No Water, Fill

Troubleshooting Procedures

!WARNING

To avoid risk of electrical shock, personal injury or death, disconnect power to unit before servicing, unless testing requires power.

Selection	Component	Function
Rotary cycle		1st press
selector set to		Drain Pump
Quick Wash. Press	Drain Pump	on. 2nd press
Rotary Selector		Drain Pump
Knob.		off.
Press Delay switch		1st press
pad	Motor	Motor on. 2nd
		press Motor
		off.
Press Chime	Door Lock	1 Attempt to
switch pad		unlock
Press Temperature	Door Lock	Lock Door
switch pad
Rotary cycle	Bleach Valve	1st press
selector set to		Fabric
Colors. Press	and Cold	Softener fill.
Rotary Selector	Water Valve	2nd press
Knob.		valves off
Press Rinse & Spin		1st press
switch pad	Heater	heater on. 2nd
		press heater
		off.

Display Diagnostic Codes

The diagnostic code display can be toggled on and off from Service Mode by pressing the Rinse&Spin

key and rotating the cycle select knob. The display will show a “d”. Rotating the Cycle Selector knob in either direction will cycle through the list of codes one code at a time with no wrap. Once an initial direction is selected by the user (either Clockwise or Counterclockwise), subsequent movements of the knob in the same direction will show older codes. If the user changes direction and turns the knob in the opposite direction, the more recent code will be displayed. If rotation is continued to the limits of the list, the display will remain at the top or the end of the list. A pair of dashes “- -” will be displayed at the end of the list of codes, when the control reaches the top, it will again show “d”. A code generated during the current cycle will be displayed with the Spin Indicator LED turned “ON”. If no cycle is currently running, a code generated during the previous cycle will be displayed with the Spin Indicator LED turned “ON”. Access Other Features While a diagnostic code is displayed, if the Rotary Selector is pressed and held, the machine will display the number of cycles since the diagnostic code occurred. To clear the diagnostic list press the Delay and Chime keys for 3 seconds while viewing the list.

A code generated during the current cycle will be displayed with the Spin Indicator LED turned “ON”. If no cycle is currently running, a code generated during the previous cycle will be displayed with the Spin Indicator LED turned “ON”.

Cycle Count Since A Diagnostic Code

Occured/Clearing Diagnostic Codes

While a diagnostic code is displayed, if the Rotary Selector is pressed and held, the machine will display the number of cycles since the diagnostic code occurred. To clear the diagnostic list press the Delay and Chime keys for 3 seconds while viewing the list.

Diagnostic Codes

Diag.	Description	Trigger	Action to be
Code			taken
		The water
		level fails to	Displays "nd"
		drop below
		the Low	Go to "Will Not
1	No Drain	Water level	Drain"
		reset within	Troubleshooting
		15 minutes,	Section
		before a spin
		begins.
	The door	Door failed to	Displays "LO" Go to
2	fails to	unlock after	"Will Not Unlock"
	unlock	3attempts	Troubleshooting
			Section
		Continuous fill	Displays "nF"
		of 12	Go to "No Water
3	No Fill	minutes.
			Fill"
		Total fill of
		14minutes.	Troubleshooting
			Section
	The door	Door failed to	Displays "FL" Go to
		lock after 3	"Will not lock"
4	fails to lock
		attempts	Troubleshooting
			Section.
5-7		Not Used

18 16025909 Rev. 0 ©2005 Maytag Services