Service and Disassembly Procedures
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit and discharge capacitor through a 10,000 ohm resistor before attempting to service, unless test procedures require power to be connected. Ensure all ground wires are connected before certifying unit as repaired and/or operational.
PC Board | Technical Sheet |
Removal
1.Disconnect power to the machine.
2.Remove the Inner Door Panel. (See paragraph Inner Door Panel removal).
The Dishwasher Technical Sheet is located behind the Toe Panel. The Schematic Diagram is unique to each model and contains the following:
Timing Sequence Chart
Load Readings
3.To access PC Board, remove 1/4" screw on PC Board Housing Cover.
4.To remove PC Board, loosen (2) 1/4" screws securing PC Board Base to Control Panel.
5.Remove pin and ribbon connectors from PC Board.
6.Depress tabs on PC Board Housing to remove PC Board.
Component Specifications
Manual Function Test
Field Service Test
Electrical Schematic
Control Panel
| The Membrane/Facia on the Control Console is not | ||
| replaceable. |
| |
| Removal |
| |
| 1. | Disconnect power to the machine. | |
| 2. | Remove the Inner Door Panel. (See paragraph Inner | |
|
| Door Panel removal). | |
| 3. | Remove PC Board Housing Cover. (See paragraph | |
|
| PC Board removal). | |
| 4. | Disconnect Membrane Switch from PC Board. | |
| 5. | Remove PC Board Base. | |
| 6. | Lift out Latch Assembly. | |
| 7. | Remove 4 screws securing Control Panel to Outer | |
|
| Door. |
|
| NOTE: Facia is susceptible to damage during | ||
|
| reinstallation. |
|
| DOOR LATCH STRIKE | ||
| The Door Latch serves as a mechanical actuator for Door | ||
| Switch operation and provides door tension for proper | ||
| door seal. |
| |
| 16021814 Rev. 0 | ©2002 Maytag Appliance Sales Company | |
