Maytag MDBH950AW manual Wax Motor Detergent / Rinse Dispenser, Vent, Wire Cover, Removal, 5-22

Service and Disassembly Procedures

!WARNING

To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit and discharge capacitor through a 10,000 ohm resistor before attempting to service, unless test procedures require power to be connected. Ensure all ground wires are connected before certifying unit as repaired and/or operational.

Wax Motor Detergent / Rinse Dispenser

Removal

1.Disconnect power to the machine.

2.Remove the Inner Door Panel. (See paragraph Inner Door Panel removal).

3.Remove the 6 mounting screws securing the Detergent Dispenser mounting bracket.

4.To remove the Wax Motor, pry out of retainer. NOTE: It is not necessary to remove Detergent

Dispenser before removing Wax Motor.

Vent

The Vent is located on the Inner Door Panel to allow moisture to be vented outside of the Dishwasher during the dry cycle.

Removal

1.Disconnect power to the machine.

2.Remove the Inner Door Panel. (See paragraph Inner Door Panel removal).

3.Rotate Vent Cover counter clockwise 1/4 turn and lift off.

	Wire Cover
	The Wire Cover retains the Wire Harness to the bottom of
	the Tub. It is located on the bottom side of the Tub.
	Removal
	1.	Disconnect power to the machine.
	2.	Remove Front Support and Toe Panel. (See paragraph
		Front Support and Toe Panel removal).
	3.	Remove 2 screws securing Wire Cover to bottom of
		Tub.
	4.	Feed Wire Harness out of bracket.
5-22	16021814 Rev. 0		©2002 Maytag Appliance Sales Company