DISHWASHING ESSENTIALS
HOT WATER
For optimal cleaning and drying results, hot water is necessary. The incoming water temperature should be
To check the incoming water temperature, turn on the hot water faucet nearest the dishwasher and let it run into a glass in the sink. Place a candy thermometer in the glass and check the temperature once it has stopped rising. If the temperature is below 120° F (49° C), have a qualified per- son raise the water heater thermostat set- ting.
Before starting the dishwasher, turn on the hot water faucet and let it run until the water is hot.This assures that the initial fill of water is hot.
DETERGENT
Use a detergent designed specifically for use in an automatic dishwasher. Be sure it is fresh and stored in a cool, dry place (not under the sink).
RECOMMENDED AMOUNT
Too little detergent results in poor clean- ing, hard water filming/spotting and poor drying. Too much detergent can cause per- manent etching/cloudiness.
The amount of detergent to use is deter- mined by the hardness of the water and
soil level of the load. Refer to the follow- ing chart for detergent usage recommen- dations.
Do not use detergent with Rinse Only. Leave the detergent lid open when running Rinse Only.
In extremely hard water conditions (13 grains per gallon or more*), it is difficult to achieve good results with any dishwasher. A mechanical water softener may be nec- essary to improve water quality, detergent effectiveness, and protect the dishwasher parts from the damage that hard water can cause.
Water Hardness* | Soil Level | Detergent Amount** |
Soft | Light Soil | 5 teaspoons |
| Normal Soil | 6 teaspoons |
| Heavy Soil | 8 teaspoons |
Medium | Light Soil | 7 teaspoons |
| Normal Soil | 8 teaspoons |
| Heavy Soil | 10 teaspoons |
Hard | Light Soil | 9 teaspoons |
| Normal Soil | 10 teaspoons |
| Heavy Soil | 12 teaspoons |
|
|
|
*Your local water utility or state university exten- sion service can tell you the degree of water hardness in your area.
**Add recommended amount of detergent to either side of the Main Wash compartment.
RINSE AID
Regular use of a rinse aid improves drying, reduces spotting and filming, and reduces moisture left on the dishwasher interior.
An automatic rinse aid dispenser is located next to the detergent cups. The window next to the dispenser cap indicates when the rinse aid reservoir needs to be refilled. When the level of rinse aid is below the
indicator marks and the window is nearly clear, it is time to refill the dispenser.
Check the dispenser monthly.
To add rinse aid to the dispenser, turn the cap counterclockwise to open. Remove the cap and pour liquid rinse aid into the opening. The amount of rinse aid dispensed during the cycle is adjustable by moving the lever inside the reservoir area. For most water conditions use manufacturers rec- ommended setting of “3”. Adjust it up to
the “MAX” setting for hard water. Set the lever anywhere between these amounts as needed to get the best results. Replace the cap and turn it clockwise to close.
©2002 Maytag Appliance Sales Company | 16021814 Rev. 0 |
