Maytag SL-3 Hitting the washer frame. Illustration #1 Illustration #4

CLEANING THE DISPENSERS
Removing the Fabric Softener Dispenser			Replacing the Fabric Softener Dispenser
1. Grasp the corner lip of the fabric softener dispenser.			1. Grasp the overflow grate so the word “CAUTION”
Lift the dispenser up and tip it to the left to avoid			can be read. Place it in the dispensing compartment.
hitting the washer frame. (Illustration #1)			(Illustration #4)
2. Under the fabric softener dispenser in the dispensing			2. Place the light blue siphon cap over the stand pipe in
compartment is an overflow grate. Grasp the overflow			the fabric softener dispenser. It should fall into place.
grate by the word “CAUTION” and pull it up and out			(Illustration #5)
of the dispensing compartment. (Illustration #2)			3. Grasp the corner lip of the fabric softener dispenser.
3. Take the fabric softener dispenser and the overflow			Tilt it slightly to the left and insert it back into the
grate to the sink. Be careful, there may be fabric			dispenser compartment. (Illustration #6)
softener left in the dispenser. Lift the light blue siphon
cap out of the fabric softener dispenser. (Illustration #3)
4. Run warm water over the dispenser, light blue siphon
cap and overflow grate to remove any build-up. A soft
cloth may be used to remove excess residue.
#1	#2		#3
				/4 CUP
				L 3
			MAX	FIL
					CU	P
				1/2
#4	#5		#6
			1/2 CUP
	MAX FILL	DILUTED

NOTE: Maytag does not recommend placing the plastic dispenser parts in the dishwasher. If laundry additives were on the parts when washed in the dishwasher, they may cause over-sudsing in the dishwasher.

10