B C
/
'_E
3.
A. Neutral ground wire
B. Fxternal ground conductor screw
C. C_'nte'r silver-colored terminal block screw
D. Neutral wire twhite or center wire)
E. _" ( 1.9 cm) U_ listed strain re'lief
Place the hooked ends of the other power supply cable wires under the outer terminal
block screws (hooks facing right). Squeeze hooked ends together, lighten screws.
!! !!
4. Tighten strain relief screw.
5. Insert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-
down screw.
6. You have completed your electrical connections. Now go to "Venting Requirements."
Optional 3-wire connection
Use for direct wire or power supply cord where local codes do not permit connecting
cabinet-ground conductor to neutral wire.
1. Remove center silver-colored terminal block screw.
2. Remove neutral ground wire from external ground conductor screw. Connect neutral
ground wire and the neutral wire (white or center wire) of power supply cord/_able under
center, silver-colored terminal block screw. Tighten screw.
A. Fxt_'rnal ground conductor screw
B. Neutral ground wire
C. C_'nter silve'r-colore'd terminal block scre'w
D. Neutral wire (white' or center wire')
E. _" (1.9 cm) UL listed strain relie'f
t. Grounding path dete'rmined by a qualifie'd electrician
Connect the other wires to outer terminal block screws. Tighten screws.
4. Tighten strain relief screws.
5. Insert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-
down screw.
6. Connect a separate copper ground wire from the external ground conductor screw to an
adequate ground.