Maytag MED5591TQ0, MED5591TQ1, W10088776A Checkthelevelnessofthedryer,Checklevelnessfirstsidetoside,thenfronttoback.

Checkthelevelnessofthedryer,Checklevelnessfirstsidetoside,thenfronttoback.

1. Place towel (A) on top of dryer to protect surface.

2. Open dryer door. Remove bottom screws from cabinet side of hinges (C). loosen (do not

remove/top screws from cabinet side of hinges.

3. lift door until top screws in cabinet are in large part of hinge slot. Pull door forward off

screws. Set door (handle side up) on top of dryer. Remove top screws from cabinet.

4. Remove screws attaching hinges to door.

5. Use a small, flat-blade screwdriver to gently remove 4 hinge hole plugs (D) on left side of

cabinet. Insert plugs into hinge holes on right side of cabinet.

Insert screws into bottom holes on left side of cabinet. Tighten screws halfway. Position

door so large end of door hinge slot is over screws. Slide door up so screws are in bottom

of slots. Tighten screws. Insert and tighten top screws in hinges.

Close door and check that door strike aligns with door catch (B). If it is needed, slide door

catch left or right within slot to adjust alignment.

1. Check that all parts are now installed. If there is an extra part, go back through the steps to

see which step was skipped.

2. Check that you have all of your tools.

3. Dispose of/recycle all packaging materials.

4. Check the dryer's final location. Be sure the vent is not crushed or kinked.

5. Check that the dryer is level. See "kevel Dryer."

6. In the U.S.A.

• For power supply cord installation, plug into an outlet. For direct wire installation,

turn on power.

In Canada

• Plug into a grounded 4 prong outlet. lurn on power.

7. Remove any protective film on the console and any tape remaining on the dryer.

8. Read "Dryer Use."

9. Wipe the dryer drum interior thoroughly with a damp cloth to remove any dust.

10. Set the dryer on a full heat cycle (not an air cycle) for 20 minutes and start the dryer.

If the dryer will not start, check the following:

• Controls are set in a running or "On" position.

• Start button has been pushed firmly.

• Dryer is plugged into an outlet and/or electrical supply is on.

• Household fuse is intact and tight, or circuit breaker has not tripped.

• Dryer door is closed.

11. When the dryer has been running for 5 minutes, open the dryer door and feel for heat. [f

you feel heat, cancel cycle and close the door.

If you do not feel heat, turn off the dryer and check the following:

• There may be 2 household fuses or circuit breakers for the dryer. Check that both fuses

are intact and tight, or that both circuit breakers have not tripped. [f there is still no

heat, contact a qualified technician.

NOTE: You may notice a burning odor when the dryer is first heated. This odor is common

when the heating element is first used. The odor will go away.