Put power supply cord through the strain relief. Be sure that the wire insulation on the
power supply cord is inside the strain relief. The strain relief should have a tight fit
with the dryer cabinet and be in a horizontal position. Do not further tighten strain
relief screws at this point.
Style 2: Direct wire strain relief
• Unscrew the removable conduit connector and any screws from a 3/4"(1.9 cm) U[.
listed strain relief (U] marking on strain relief). Put the threaded section of the strain
relief through the hole below the terminal block opening. Reaching inside the
terminal [)lock opening, screw the removable conduit connector onto the strain relief
threads.
t
A. Removable conduit connector
B. Hole below terminal block opening
(. Strain relief threads
• Put direct wire cable through tile strain relief. ]he strain relief should have a tight fit
with the dryer cabinet and be in a horizontal position. Tighten strain relief screw
against the direct wire cable.
II
4. Now complete installation following instructions for your type of electrical connection:
4-wire (recommended)
3-wire (if 4-wire is not available/
Electrical Connection Options
If your home has: And you will be Go to Section
connecting to:
4-wire receptacle A U 1.listed, 4-wire connection:
(NEMA Type 14-;¢0R) 120/240-volt minimum, Power supply cord
_& 30-amp, dryer power
supply cord*
4-wire direct A fused disconnect or 4-wire connection:
circuit breaker box* Direct Wire
(12.7 cm)
3-wire receptacle
(NEMA type 10-30R)
©A UI. listed,
120/240-volt minimum,
30-amp, dryer power
supply cord*
3-wire connection:
Power supply cord
3-wire direct A fused disconnect or 3-wire connection:
circuit breaker box* Direct Wire
*If local codes do not permit the connection of a cabinet-ground conductor to the neutral
wire, go to "Optional 3-wire connection" section.
.... 9