Gather the required | tools and |
| parts | before | starting | installation. | Read and follow the | ||||
instructions provided with any tools listed here. |
|
|
|
| |||||||
screwdriver | • | Tin | snips/new | vent | |||||||
#2 | Phillips | screwdriver |
| installations/ |
|
| |||||
|
|
|
|
| |||||||
Adjustable | wrench | that | • | kevel |
|
| |||||
opens | to 1" (2.54 | cm) or | • | Vent clamps |
| ||||||
• | Caulking gun | and | |||||||||
(for adjusting | dryer feet) | ||||||||||
| compound | (for installing | |||||||||
|
|
|
|
|
|
| |||||
Wire | stripper | (for | U.S. |
| new exhaust vent) | ||||||
only, | direct |
| wire |
|
|
|
|
|
| ||
installations) |
|
|
| • | lape | measure |
| ||||
Parts supplied
Remove parts packages from dryer drum. Check that all parts are included.
4 Lew_lhlg legs
Parts needed
Check local codes. Check existing electrical supply and venting. See "Electrical Requirements" and "Venting Requirements" before purchasing parts.
Mobile home installations require metal exhaust system hardware available for purchase from the dealer from whom you purchased your dryer. For further information, please refer to the "Assistance or Service" section.
Explosion Hazard
Keep flammable materials and vapors, such as gasoline, away from dryer.
Place dryer at least 18 inches (46 cm) above the floor for a garage installation.
Failure to do so can result in death, explosion, or fire.
You will need
•A location that allows for proper exhaust installation. See "Venting Requirements."
•A separate
•[f you are using a power supply cord, a grounded electrical outlet located within 2 ft (61 cm) of either side of the dryer. See "Electrical Requirements."
•A sturdy floor to support the total weight (dryer and load) of 200 Ibs (90.7 kg). The combined weight of a companion appliance should also be considered.
•A level floor with a maximum slope of 1" (2.5 cm) under entire dryer. ([f slope is greater than 1" [2.5 cml, install Extended Dryer Feet Kit, Part Number 279810.) Clothes may not tumble properly and models with automatic sensor cycles may not operate correctly if dryer is not level.
Do not operate your dryer at temperatures below 45°F (7°C). At lower temperatures, the dryer might not shut off at the end of an automatic cycle. Drying times can be extended.
[he dryer must not be installed or stored in an area where it will be exposed to water and/or weather.
Check code requirements. Some codes limit, or do not permit, installation of the dryer in garages,closets,mobile homes or sleeping quarters. Contact your local building inspector.
Installation Clearances
The location must be large enough to allow the dryer door to open fully.
4
