ELECTRONIC CONTROL SETUP INSTRUCTIONS
WHITES COLORS BRIGHTS
PERM. DELICATES QUICK
PRESS AND KNITS CYCLE
WASHER
Washer control
NOTE: After the washer/dryer has been installed and plugged in, the display will show “0 MINUTES” on the washer and dryer portions of the display. After the washer and dryer doors have been opened and closed, the display will show the price for each machine. On washer/dryers set for free cycles, the display sections will flash “SELECT CYCLE.”
1.PD Models: Insert coins until “SELECT CYCLE” flashes on the display portion of the washer or dryer that is to be run.
PR Models: A debit card is required rather than coins. Generation 1 or 2 debit card systems may be used; but when the Generation 2 debit system is used, the controls will automatically be set to Enhanced Debit mode (J. Ed). In Enhanced Debit mode, the card balance will also display when a debit card is inserted into the reader.
2.Door must be closed on the desired washer/dryer before cycle selection is made.
3.Press the fabric setting button for the washer/dryer cycle desired. After the cycle is started, the time will display and count down.
4.If a cycle is interrupted by opening the door or power loss, “RESELECT CYCLE” will flash in the display. To restart the washer/dryer, close door and reselect desired cycle.
NOTE: When set for free vend operation an ongoing dryer cycle will cancel if the door is opened.
DRYER
WHITES PERM.
& COLORS PRESS DELICATES
Dryer control
General Washer/Dryer User Information
SCROLLING “OUT OF ORDER” MESSAGE, FOLLOWED BY A FAILURE OR DIAGNOSTIC CODE, SHOWING IN DISPLAY – This condition indicates the washer/dryer is inoperative. Diagnostic codes being displayed on the upper portion of the display pertain to the dryer section, and diagnostic codes displayed on the lower portion of the display apply to the washer section. Diagnostic codes displayed on both the upper and lower portions of the display pertain to the control system of both the washer and dryer.
“0 MINUTES” SHOWING IN DISPLAY – This indicates the cycle is complete and the washer/dryer cannot be operated. Coins dropped or debit inputs during this condition will be stored in escrow but cannot be used until normal operation is restored by opening and closing the door. If a door switch has failed, causing “0 MINUTES” to remain in the display after the door is opened and closed, it must be replaced before normal operation can be restored.
COLD START (Initial first use) – Washer/dryer is programmed at the factory as follows:
Washer |
| ||
| $1.75 wash price (PD models) | ||
| $0.00 wash price (PR models) | ||
| 3 rinses (extra rinse not enabled) | ||
Dryer | 5 minutes per quarter for PD models | ||
| 45 minutes dry time for PR models | ||
| $1.50 dry price (fixed | cycle | with top off – PD |
| Models) |
|
|
| $0.00 dry price (fixed | cycle | – PR Models) |
33
