How to Operate the C2200
How to Operate the C2200
The McIntosh C2200 Tube Preamplifier has been factory configured for operating settings that allow immediate en- joyment of superb high fidelity audio without the need for further adjustments. If you wish to make changes to the fac- tory default settings, refer to the SETUP Section of this Owner’s Manual.
Power On and Off
Press the POWER switch to ON, the Red LED above the STANDBY/ON
Notes: For normal operation, switch the C2200 On and Off with the Standby/On
The amount of time the Front Panel Alphanumeric Display indicates TUBE WARMUP is dependant upon the temperature of the Tubes inside the C2200.
Figure 24
Input Source Selection
Select the desired Source with the INPUT Control or the Source
Volume Control
Adjust the VOLUME Control or the UpS /DownT
Record Monitor
Press the REC MONITOR Push- button to hear the TAPE/REC Playback Signal during the re- cording process.
Tone Bypass
Press the TONE BYPASS Push- button to totally Bypass the Tone Control Circuitry, providing a flat frequency response. If the AUTOTONE circuit is set to the On position in Setup Mode, the C2200 will remember for each input whether the Tone Bypass is active.
Bass and Treble Controls Adjust the BASS and TREBLE controls to suit your listening preferences. The Bass or Treble intensity can be increased with clockwise rotation and decreased with counterclockwise rotation.
Figure 26
Figure 25
19