Mono
Press the MONO Mode
Note: The TAPE/REC Outputs are not effected by the Mono Mode of Operation.
Balance Control
Adjust the BALANCE Control as needed to achieve ap- proximately equal listening volume levels in each Loud- speaker. Rotate the BALANCE Control clockwise to em- phasize the Right Channel by reducing the volume level of the Left Channel. Refer to figure 27.
Figure 27
Several seconds after the rotation of the BALANCE Con- trol has stopped, the Front Panel Alphanumeric Display will once again indicate the Input Source and Volume together with the “>” symbol to show that the Right Channel is now louder than the Left Channel. Refer to figure 28.
Figure 28
Rotate the BALANCE Control counterclockwise to deemphasize the Right Channel until equal Balance of both Channels is achieved. Refer to figure 29.
Figure 29
Mute
Press the MUTE
Figure 30
Setup
Pressing the SETUP
Output 1 and 2
Press OUTPUT 1 or 2
Meter Lights
Rotate the METER LIGHTS Control counterclockwise to switch Off the Meter Illumination and rotate the control clockwise to switch On the Meter Illumination.
Note: It is normal for the brightness of the Front Panel Alphanumeric Display to dim when the Meter Illumination is switched Off. Refer to page 14 for additional information.
Pass Thru Mode
When the C2200 is connected together with a McIntosh Multichannel A/V Control Center or Surround Decoder and has the PASS THRU MODE activated, it will automatically
Figure 31
In the PASS THRU Mode, the OUTPUTS 1&2 Push- buttons remain active. The remaining C2200 Front Panel Controls and
Note: The C2200 Preamplifier remembers separately, the setting of the OUTPUTS 1&2
Reset of Microprocessors
In the event that the controls of the C2200 stop functioning, push the POWER switch OFF and wait about two minutes. Then push the POWER switch ON followed by pushing the STANDBY/ON
Note: The above condition is usually caused by either interruptions in AC power and/or major changes that may occur in AC power line voltage.
20