Memorex MT2024 manual Important Safety Instructions

IMPORTANT SAFETY INSTRUCTIONS (CONTINUED)

15. OVERLOADING
Do not overload wall outlets and extension cords as this can result in a risk of fire or electric shock.
16. OBJECT AND LIQUID ENTRY
Never push objects of any kind into this product through openings as they may touch dangerous voltage points or short out parts that could
result in fire or electric shock. Never spill or spray
any type of liquid on the product.
17. OUTDOOR ANTENNA GROUNDING				ANTENNA
If an outside antenna is connected to the				LEAD IN
				WIRE
product, be sure the antenna system is
grounded so as to provide some protection	GROUND
against voltage surges and built-up static	CLAMP
charges. Section 810 of the National Electric				ANTENNA
Code, ANSI/NFPA 70, provides information with				DISCHARGE UNIT
				(NEC SECTION 810-20)
respect to proper grounding of the mast and
supporting structure, grounding of the lead-in	ELECTRIC
wire to an antenna discharge product, size of	SERVICE			GROUNDING CONDUCTORS
	EQUIPMENT			(NEC SECTION 810-21)
grounding conductors, location of antenna			GROUND CLAMPS
discharge product, connection to grounding		POWER SERVICE GROUNDING
electrodes and requirements for grounding	NEC - NATIONAL ELECTRICAL CODE	ELECTRODE SYSTEM
		(NEC ART 250, PART H)
electrodes.	S2898A
18. SERVICING	EXAMPLE OF ANTENNA GROUNDING AS PER
Do not attempt to service this product yourself as
opening or removing covers may expose you to	NATIONAL ELECTRICAL CODE
dangerous voltage or other hazards. Refer all servicing to qualified service personnel.
19. REPLACEMENT PARTS

When replacement parts are required, be sure the service technician uses replacement parts specified by the manufacturer or those that have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock or other hazards.

20. SAFETY CHECK

Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition.

21. WALL OR CEILING MOUNTING

The product should be mounted to a wall or ceiling only as recommended by the manufacturer.

22. DAMAGE REQUIRING SERVICE

Unplug the product from the wall outlet and refer servicing to qualified service personnel under the following conditions: a. When the power-supply cord or plug is damaged.

b. If liquid has been spilled or objects have fallen into the product. c. If the product has been exposed to rain or water.

d. If the product does not operate normally by following the operating instructions. Adjust only those controls that are covered

by the operating instructions, as an adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to its normal operation.

e. If the product has been dropped or the cabinet has been damaged.

f. When the product exhibits a distinct change in performance–this indicates a need for service.

23. HEAT

The product should be situated away from heat sources such as radiators, heat registers, stoves or other products (including amplifiers) that produce heat.

24. NOTE TO CATV SYSTEM INSTALLER

This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

4