Mercury
Specification |
|
General |
|
Power requirements: |
|
Supply Voltage Range: | 100 - 240 Vac ±10% |
Supply Frequency: | 50 - 60 Hz ±10% |
Maximum supply current: | <1 Amp (With no relay loads) |
Typical supply current: | <0.5 Amp |
Operating temperature range: | +50C to +500C |
Operating Humidity: | 80% maximum |
Storage temperature range: | |
Environmental: | Indoor use at altitudes up to 2000m, Pollution Degree 1, |
| Installation Category II. |
| Voltage fluctuations not to exceed ±10% of nominal voltage |
Size: | 110mm (W) x 60mm (H) x 100mm (D) |
Weight: | 150 Grams |
Safety: | EN61010 |
EMC: | EN61326; 1997 +Amdt. A1; 1998 |
Ventilation: | There is no requirement for forced cooling ventilation |
Class 2 Insulation: | No protective Earth is required and none should be fitted. |
The host equipment must provide a suitable external
Fuse: | 6.3A 240 Vac Antisurge (T) HRC conforming to IEC 60127 |
Or MCB: | 8A, 240 VAC Type C conforming to BS EN 60898 |
The host equipment must provide adequate protection against contact to hazardous live parts.
Relays |
|
|
Max current relay 1: | 6A (non inductive) |
|
Max Voltage relay 1: | 260Vac (external supply) |
|
Exclusive common |
|
|
Max current relay 2: | 4A (non inductive) | Relays 2 and 3 share a common |
Max Voltage relay 2: | 260Vac (external supply) | supply line and the loads can |
Shared common with relay 3 |
| have a combined total of 8A. |
|
| Relay 2 or 3 can switch a maximum |
Max current relay 3: | 4A (non inductive) | of 6A provided the other is at 2A or. |
Max Voltage relay 3: | 260Vac (external supply) | lower. |
Shared common with relay 2 |
|
|
Max current relay 4: | 3A (non inductive) |
|
Max Voltage relay 4: | 260Vac (Internal supply) |
|
Common connected to Input "live" |
|
|
Max current relay 5: | 3A (non inductive) |
|
Max Voltage relay 5: | 260Vac (Internal supply) |
|
Common connected to Input "live" |
|
|
For compliance with the LVD, relays 2 and 3 common must be at the same potential as the supply voltage.
! | Warning: |
|
|
Relays 4 and 5 outputs have hazardous voltages (Supply input voltage potential). |
| ||
| Ensure that all power is |
|
|
| switched off before |
|
|
| installing or maintaining |
|
|
| this product | Revision 1.2 | Page 16 of 21 |