Mercury
Installation:
Panel Cut-out:
17mm
72mm
34mm
93mm
2 holes: 3.5mm dia.
Fixing:
The controller can be fixed either by 2 X M3 screws from the rear or by the plastic retaining device (PR0329), obtainable from RDM.
Clearances:
The controller must have 5mm clearance above the top and below bottom, and 25mm clearance from the sides. Clearance at the rear is dependant on the wiring.
There is no requirement for forced cooling ventilation
Ensure that all power is |
|
|
switched off before |
|
|
installing or maintaining |
|
|
this product | Revision 1.2 | Page 18 of 21 |
