
To select a standard setting
Warning! Selecting Type will reset the 541 Surround Controller to one of a standard set of configurations. If you want to make changes to the configuration of an existing system use Config; see Specifying information about your system on the next page. With Config you can alter any Type to match any system.
●Switch off any power amplifiers that are connected to the surround controller.
●Switch off the surround controller, using the power switch on the back panel.
●Switch on the power again while holding down the Off key on the front panel.
Type
The display will show:
Type 1
followed by:
● Press A or V on the front panel to change the Type number.
For example, to select Type 3 for use | Type | 3 LP |
| ||
with a phono module the display shows: |
|
|
●Wait for one second, and then switch off the surround controller using the power switch on the back panel.
●Switch on again to use the standard settings you have selected.
37