Specifying information about your system
If none of the standard settings exactly matches your requirements choose the one that is closest, and then use the 541 Surround Controller’s configuration menus, called Config, to make the necessary changes to the appropriate parameters.
The procedures for doing this are described in the following sections of this chapter.
To specify the type of centre speaker
●Switch off the surround controller, using the power switch on the back panel.
●Switch off any power amplifiers that are connected to the surround controller.
●Switch on the power again while holding down the Display key on the front panel.
The display will show: | Config |
| |
|
| ||
● Press > or < until you see a |
|
|
|
| Centre Norm |
| |
|
|
| |
display such as: |
|
|
|
●Press A or V to step between the alternative options, as shown in the following table:
Option | Description |
| Norm | Normal centre speaker; bass handled |
| by left and right main loudspeakers. |
| Wide | |
| bass response. |
| Phan | No centre present; phantom centre |
| signal created by left and right main |
| loudspeakers. |
When you have chosen the Centre option you want to use proceed to the next step.
38