To connect to Meridian 600 or 200 Series equipment
If your system includes any Meridian 600 or 200 Series units, with 600 COMMS or 200 COMMS sockets, you should set all the 500 Series units to 200 COMMS operation using the following procedure:
●Turn off the control unit, using the power switch on the back panel.
●Turn on the power again while holding down the Off key on the front panel.
The display will show the current | Type | 1 |
Type setting:
●Press A and V on the front panel to change the Type setting to Type 2.
Type 2
The display will show:
●Switch the power off and on again to restore the control unit to normal operation.
●Configure the Meridian System Remote for 601 operation; see the Meridian System Remote User Guide for details.
●To return to 500 COMMS operation repeat the above procedure, and select any type apart from Type 2. For more information see Choosing standard settings, page 36.
What next?
Congratulations – your 541 Surround Controller is now set up and ready for use. Refer to the chapter Using the surround controller for details of using the surround controller with your music and cinema sources.
47