Quick Start

3

2

1

1.Connect the 10-pin RJ45 male connector into the jack on the Voyager. You will hear a ‘click’ when the connection is made.

2.Connect the L-shaped plug of the power supply into the power jack on the PowerLink cable.

3.Connect the power supply into an AC outlet. Make sure the AC input requirements of the power supply match the AC outlet.

4

4.When the Voyager is ready to scan, the green LED will turn on, the red LED will flash and the scanner will beep once.

5

5.Place a bar code in front of the scanning window. The scanner will beep once and flash the red LED if the bar code was successfully decoded. For the MS9540, press the CodeGate button to transmit the data.

NOTE: Voyager is shipped from the factory programmed with default settings. Refer to the METROSELECT® Programming Guide for instructions on how to configure the scanner.

3

Page 8
Image 8
Metrologic Instruments MS9500 manual Quick Start