Audible Indicators
When the Voyager is in operation, it provides audible feedback. These sounds indicate the status of the scanner. Eight settings are available for the tone of the beep (normal, 6 alternate tones and no tone). To change the tone, refer to the MetroSelect Programming Guide MLPN 2407.
One Beep | |
When the scanner first receives power, the green | |
| LED will turn on, then the red LED will flash and the |
| scanner will beep once. (The red LED will remain on |
| for the duration of the beep.) The scanner is ready to |
| scan. |
| When the scanner successfully reads a bar code, the |
| red LED will flash and the scanner beeps once (if |
| programmed to do so). If the scanner does not beep |
| once and the green light does not flash, then the bar |
| code has not been successfully read. |
|
| Razzberry Tone |
|
| This tone is a failure indicator. Refer to |
|
| “Failure Modes"page 13. |
| Three Beeps - During Operation | |
| ||
| When entering configuration mode, the red LED will | |
|
| flash while the scanner simultaneously beeps three |
|
| times. The red and green LEDs will continue to flash |
|
| while in this mode. Upon exiting configuration mode, |
|
| the scanner will beep three times, and the LEDs will |
|
| stop flashing. |
|
| When configured, 3 beeps can also indicate a |
|
| communications timeout during normal scanning |
|
| mode. |
|
| When using |
|
| beep three times (the current selected tone), followed |
|
| by a short pause then by a high tone and a low tone. |
|
| This tells the user that the single configuration bar |
|
| code has successfully configured the scanner. |
| Three Beeps - On Power Up | |
| ||
|
| |
|
|
|
10
