31
Appendix B – Default Settings
Many functions of the scanner can be “programmed” – that is, enabled
or disabled. The scanner is shipped from the factory programmed to a
set of default conditions. The default parameter of the scanner has an
asterisk (*) in the charts on the following pages. If an asterisk is not in
the default column then the default setting is OFF or DISABLED. Every
communication does not support every parameter. If the
communication supports a parameter listed in the charts on the following
pages, a check mark will appear.
PARAMETER DEFAULT OCIA RS-232 LIGHT
PEN IBM
46XX KBW
Normal Scan Mode *   
Continuous Scan Mode   
Blinky Scan   
Continuous Blinky Scan  
Custom (one shot) Scan   
Long-Range In-Stand *   
Short-Range In-Stand   
Long-Range Out-of-Stand *   
Short-Range Out-of-
Stand   
CodeGate Active In-
Stand   
CodeGate Inactive In-
Stand *   
CodeGate Active Out-of
Stand *   
CodeGate Inactive Out-of
Stand   
UPC/EAN *   
Code 128 *   
Code 93 *   
Codabar *   
Interleaved 2 of 5 (ITF) *   
MOD 10 check on ITF  
Code 11   
Code 39 *   
Full ASCII Code 39   