Metz SCA 3202-M manual Mounting the adapter, On the mecablitz 44 MZ-2, On the mecablitz 54 MZ

1.2Mounting the adapter

☞All units involved must be switched off before mounting or dismounting the SCA adapter on / from the mecablitz or on / from the ca- mera.

on the mecablitz 40 MZ-..., 45 CL-4 digi, 50–MZ-5, 70 MZ-... and 76 MZ-5 digi:

•Turn the flash unit’s foot by 90° (40 MZ-... only).

•Press the retention catch against the casing, simultaneously pushing the hitherto used stand- ard foot or SCA adapter out of the guide.

Any cover plate that may still be in place (requi- red for the 301 standard foot or SCA 300 adapter) should be gripped in the centre and withdrawn.

on the mecablitz 44 MZ-2:

•Use your fingernail to press up the locking lever in the middle of the rear side of the mecablitz and hold it depressed.

•At the same time withdraw the SCA adapter or standard foot backward.

Any cover plate that may still be in place (required for the 301 standard foot or SCA 300 adapter) should be gripped in the centre and withdrawn.

on the mecablitz 54 MZ-...:

•Open the battery compartment cover.

•Press the coloured locking knob in the battery compartment and simultaneously remove the standard foot or SCA adapter.

Any cover plate that may still be in place (requi- red for the 301 standard foot or SCA 300 adap- ter) should be gripped in the centre and with- drawn.

10