Metz SCA 3202-M Mecablitz 45 CL-4 digital, Press the mode button until HSS appears in the display

•Lightly touch the shutter release to trigger the exchange of data between the flash and the camera.

mecablitz 45 CL-4 digital

•Set the flash device to TTL or manual flash mode (see operating instructions of the flash device).

•Press the "mode" button until "HSS" appears in the display

4.10 Wake-up function for the flash unit

The 44 MZ-... and 54 MZ-... flash units feature an auto-off function that automatically switches the units off 1, 3 or 10 minutes after the last flash was fired or a setting was made. The flash unit is then in a power saving standby state. As soon as the camera’s shutter release is touched the SCA adapter will wake up the flash unit and switch it on again (wake-up function).

☞To avoid discharge of the power sources remember to switch off the flash unit by its main switch if you are not going to use it for an extended period of time.

5.Cordless Metz Remote Flash Mode

In the Cordless Metz Remote Mode a master flash unit (“controller”) mounted on the camera controls the light output of one or more slaves. For system- induced reasons the master flash unit must work in the auto flash mode (Metz Auto Remote Mode).

☞The Metz TTL Remote Mode is not supported due to the pre-flash metering system of Olym- pus digital cameras! If the master (“controller”) function is activated in TTL flash mode on the

flash unit, then the display of the SCA adap-

28