ModularEasy, Pulsar MX RT | MGE UPS Systems 4000 RT manual

1. Presentation

ModularEasy

Pulsar MX ModularEasy enables parallel operation when combining two Pulsar MX UPSs. Consequently you can enhance the availbility level of your equipment (N+1 redundancy). You can also double your secured power capacity according to your needs (migration, network extension...). In the unlikely event a major fault would occur, the manual maintenance bypass of Pulsar MX ModularEasy would allow the UPS maintenance without interrupting your connected equipment.

In single unit mode, Pulsar MX ModularEasy combined with one Pulsar MX UPS adds a second level of availability to your installation.

The manual bypass mode allows the replacement of the UPS without any interruption to the connected equipment in case of a major fault that would not be related to the most critical components of the UPS (i-e front-accessible, hot-swappable Battery and Power Sub-Modules).

Example of Pulsar MX ModularEasy connected with two UPSs in parallel operation

SWITCHED	SWITCHED
GROUP 2	GROUP 1

PARALLEL

SWITCHED	SWITCHED
GROUP 2	GROUP 1

PARALLEL

UPS 1

(Pulsar MX RT)

Pulsar MX RT ModularEasy

UPS 2

(Pulsar MX RT)

RS232 CONTACTS BAT NO. RPO

RS232 CONTACTS BAT NO. RPO

UPS output to load

AC Normal input

34008030EN/AA - Page 10

Image 10

MGE UPS Systems 4000 RT user manual Pulsar MX RT Pulsar MX RT ModularEasy

Contents

Pulsar MX 34008030EN/AA Substances IntroductionEnvironmental protection Packing Pictograms Contents Troubleshooting Technical specifications Glossary Standard positions Dimensions H x W x D in mm / InchesPresentation Tower position Rack position Rear panels Pulsar MX EXB RT optional battery modulePulsar MX 4000 RT / 5000 RT Rack mounting kit Display and control panelOptions Telescopic rails, 639 mm to 1005 mm Pulsar MX RT Pulsar MX RT ModularEasy ModularEasyPulsar MX RT Battery extensions for Pulsar MX RT Battery Integration SystemBattery extension cable 1,8 m / 6 ft Pulsar MX EXB RT Pulsar MX 4000 RT Min 29 min 53 min Unpacking and contents check InstallationInternal battery connection Battery start-up Installation in tower position Installation in rack position UPS or battery module rack mounting optional rails required Connection to the RS 232 communication port Communication portsConnection to the communication port by relays Remote power off contact normally open Remote Power Off communication portRemote power off contact normally closed Recommended downstream protection Required protective devices and cable cross-sectionsRecommended upstream protection Required cable cross-sections Connection of input/output power cables on UPS terminals Always connect first the earthing wire Connection of IEC cables to output receptacles Final start-up sequence OperationInitial start-up UPS personalisation Equipments are supplied in ECO mode Normal modeEco mode Operating modes Low battery warning Operation on battery powerTransfer to battery power End of backup time UPS shutdown Press the 0 button 28 more than 3s Maintenance menu Access to measurements and personalisation dataAccess to measurements Display organisation ON/OFF settings Local settingsOutput settings UPS set-up Personalisation using external software MaintenanceBattery settings But the operation is downgraded TroubleshootingTroubleshooting Leds 21 By the UPS Indication Diagnostic Correction Display Signification Correction Description Secure your installation power continuityLife Cycle Monitoring LCM Get free offers Reset or disable LCM Hot swapping the power sub-module MaintenanceHot swapping the battery sub-module Return to normal operation Reconnecting the battery sub-moduleMaintenance Test position Training centre Hz training centre Technical specifications Appendices Glossary 34008030EN/AA 34008030EN/AA