MGE UPS Systems EPS 7000 user manual Status Screen Display, General status screen

Users Manual

Operation

2.0Scope

This section describes procedures for normal operation of EPS 7000 Single Module systems. Including interactive front panel display, settings for language configuration, alarms message displays, voltage, current, battery measure- ments, with before and after start-up checks, emergency shutdown using EPO disconnects, and normal conditions for using forced transfers.

2.1Status Screen Display

The alphanumeric interactive status screen display, (located in the top pane of the hidden panel, see Figure 1-8), is the automatic default display for status setting configurations.

Figure 2-1: Default Status Screen Alphanumerical Display Configuration.

General status screen.

This is the default display. It automatically reappears if the control panel has not been used for ten minutes.

!

V

Alarm display

Voltage measurements

A

Current measurements

W.Hz

Frequency and power measurements

+ –

Battery measurements

Reserved for future use (on/off controls)

* to confirm

Language and screen contrast settings

toset ≥

° toconfirm

During normal operation, when there are no alarm conditions present and the load is supplied by the UPS inverter output, the display will present the general status message:

LOAD IS PROTECTED

UPS IS ON LINE

When there are alarm conditions, the display will present a general alarm message, and the user can use the “alarm” pushbutton (!) to determine the exact cause of the alarm condition, see section 2.9, Alarms.

The following sections present detailed operating instructions for the alphanumeric display.

Operation page 2 —1