IV. THERMOCOUPLE INSTALLATION
1.Install the thermocouple sensing bulb into the correct hole in the rear of the oven, as shown in Figure
Thread lead into
machinery Use for conveyor compartment here
Thread lead into
machinery Use for conveyor compartment here
Figure
Thermocouple Installation Locations
2.Thread the thermocouple lead through the grommet and into the machinery compartment.
3. Remove the
4.Thread the thermocouple lead through the side of the machinery compartment as shown in Figure
Figure
Placing the Thermocouple Leads
5.Connect the thermocouple leads to the temperature controller as shown in Figure
6.Repeat Steps
8=White=Positive
7=Red=Negative R=No Connection
Figure
Thermocouple Lead
Connections
Ground=Shielded cable