SECTION 2
INSTALLATION
SECTION 2
INSTALLATION
WARNING
Do not obstruct the flow of combustion and ventilation air to and from your oven. There must be no
obstructions around or underneath the oven.
CAUTION
For additional installation information, refer to the PS360
Marshall P/N
NOTE
There must be adequate clearance between the oven and combustible construction. Clearance must
also be provided for servicing and for operation.
NOTE
Wiring diagrams are contained in this manual (Section 5, “Electrical Schematics”) and are also
located inside the Machinery Compartment Access Panel.
NOTE
All aspects of the oven installation, including placement, utility connections, and ventilation requirements, must conform with any applicable local and national codes. These codes supercede the requirements and guidelines provided in this manual.
NOTE
In U.S.A., the oven installation must conform with local codes, or in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1. The oven, when installed, must be electrically grounded in accordance with local codes, or in the absence of local codes, with the National Electrical Code (NEC), or ANSI/NFPA70.
NOTE
In Canada, the oven installation must conform with local codes, or in the absence of local codes, with the Natural Gas Installation Code,
NOTE
For Australian installation, the oven installation must conform with AGA Code, AG601, and with any requirements of
the appropriate statutory authority.