Middleby Marshall PS360 C. Installing The Center Transition, 11 - Trim Strip Installation

7.Attach the front trim strip between the two ovens, as shown in Figure 2-11.

8.Replace the rear axial cooling fans. See Figure 2-8.

9.Perform one of the following, as appropriate:

•For PS360/360WB Tandem and Double Tandem installations, skip ahead to Part D, INSTALLING THE CONVEYOR FRAME AND BELT (Page 2-9).

•ForPS360/360WBTriTandeminstallations,perform Steps 1-8 again to attach the third oven to the two that have just been assembled. Then, skip ahead to Part D, INSTALLING THE CONVEYOR FRAME AND BELT (Page 2-9).

•For PS360/360WB Quad Tandem installations, perform Steps 1-8 again to attach the two remaining ovens to each other. Then, continue on to Part C,

INSTALLINGTHECENTERTRANSITION.

C. INSTALLING THE CENTER TRANSITION

1.Install the upper support channels to the two center ovens as shown in Figures 2-12 and 2-13.

SECTION 2

INSTALLATION

Figure 2-11 - Trim Strip Installation

Trim strip

Figure 2-12

Support Channel Installation - Lower Oven

Support

channels

Figure 2-13

Support Channel Installation - Upper Oven

Support

channels

2-7