Middleby Marshall PS360 2-11, 24 - Transition Section Final Assembly, Section Installation

5.For a TANDEM, DOUBLE TANDEM, or TRI TANDEM oven installation, skip ahead to Step 9. For a QUAD TANDEM oven installation, continue on to Step 6.

6.Slide the top transition panel into place. Then, slide the two transition side panels into place. See Figure 2-24.

7.If the four latches are not already attached to the side and top transition panels, attach them in place as shown in Figure 2-24.

8.Fasten the latches on the side and top panels to hold the panels in place.

SECTION 2

INSTALLATION

Latches

Latches

Figure 2-24 - Transition Section Final Assembly

9. LOOSELY attach the conveyor drive motor to the end wall of the oven, as shown in Figure 2-25.

10. Assemble the conveyor drive chain in place on the motor and conveyor drive sprockets.

11.Position the motor to adjust the tension of the drive chain. The deflection of the chain should be 3/4” (19mm). DONOTOVERTIGHTENTHEDRIVECHAIN.

Then, tighten the motor in place.

12. Assemble the end plugs and motor housing onto the oven.

13. TANDEM AND DOUBLE TANDEM OVENS ONLY: Assemble the end stops, conveyor crumb trays, and conveyor extension covers onto the oven. These components are illustrated in Figure 1-1 (Page 1-2).

Figure 2-25

Conveyor Motor and Drive Chain Assembly

2-11