SECTION 2
INSTALLATION
3.Remove the rear axial cooling fans that are adjacent to the mating sides of the ovens. The fans may either be completely disconnected, or left attached by their wiring as shown in Figure
4.Insert three of the supplied 1/2 x 5” bolts through the holes in the frame of the right oven, pointing outward as shown in Figure
Mating surface of
ovens (shown from
lower rear)
Wiring is still
connected
Figure 2-8 - Cooling Fan Removal
2-1/2” x 2-1/2”
(64 x 64mm)
spacers
Bolts
(64 x 203mm)
spacers
Figure 2-9 - Bolts and Spacers
5.Push the ovens together. Check that the mounting bolts, alignment plate, and sealing gasket are all properly aligned. See Figure
6. Tighten all of the attaching bolts. Check that the mating edges of the ovens align properly. If gaps appear between the tops of the ovens, it will be necessary to loosen the connecting bolts and realign the ovens.