Miele CVA 3650 Installing a built-incoffee machine, For units with 19 mm thick side walls

Installation

Installing a built-in coffee machine

Before installation make sure that there is no power supply to the machine. This also applies should it ever need to be taken out of its housing unit.

The machine must be built in before it is operated.

You will need two Allen keys (size 3 and 5) for installing the machine.

^Push it all the way into the niche until you feel resistance.

The following only applies when installing in a tall unit:

^Check the height of the machine to make sure that it is sitting centrally in the niche and that it is level.

If this is not the case, realign the 4 feet underneath the machine using the large allen key.

The feet can be unscrewed by up to approx. 10 mm.

For units with 19 mm thick side walls:

^If the furniture unit walls are 19 mm thick you will need to drill four holes in the sides for securing the machine. To mark the position of these holes:

–Align the machine in the niche. Screw the side socket screws inside the machine in a little so that they make indents in the side walls, and then unscrew them again.

–Take the machine out of the niche and drill ø 4.5 mm holes, 2 mm deep where you made the indentations.

66