Dishwasher installation
8.Securing the dishwasher to the countertop.
Push the dishwasher back into the re- cess.
Close the door and align the top of door (control panel) with the cabi- netry.
Open the door and check the verti- cal gap, left and right side of top cor- ners of wash cabinet. If distance to side walls of cabinetry is not even, push the dishwasher sideways to align.
Close the door, check the alignment of control panel again, correct if necessary and repeat the inspection of vertical gaps.
When correctly aligned, turn 2
1.3cm (1/2") stainless steel screws (supplied) into the prepared holes in top edge as shown below.
The weight of the machine must be supported by the legs, not the countertop fastening screws. If se- curing the top takes weight off of the legs, extend the legs further until they are tight against the floor.
Ensure that the seal on the top edge of the dishwasher fits directly against the worktop. If this is not the case, adjust the height screws more, (see Step 3).
Do not drill any additional holes through any portion of the wash cabinet. If in doubt about how to se- cure the dishwasher, please call the Miele Service Department.
62
