Switching the appliance ON and OFF
Before using for the first time
The stainless steel surfaces and trim are covered in a protective sheeting for transport.
^Do not remove the sheeting until the appliance has been installed in its final location. To peel the sheeting off, start at one of the upper corners.
^Next, coat the stainless steel surfaces with a special stainless steel product (which is available through customer service).
^Clean the inside of the appliance and the accessories with warm water and some mild soap. Dry with a soft cloth.
It is very important to let the appliance stand for 30 to 60 minutes after transport before you plug it in for the first time. Failure to do so can prevent the appliance from functioning properly!
Switching the appliance ON
The refigerator and freezer sections can be switched on separately, so that you can choose which sections you want on at a given time.
Refigerator section
^Press the ON/OFF button for the refrigerator section.
You will see the temperature display for the refrigerator section come on. The refrigerator will now start cooling, and
the interior light will come on when you open the door.
Freezer section
^Press the ON/OFF button for the freezer section.
You will see flashing bars in the temperature display for the freezer section, which will now start cooling.
Allow the appliance to run for a few hours before placing food in it. This will ensure that the temperature is sufficiently low.
Cool pack
Place the cool pack in the top drawer of the freezer section or, to save space, on the freezer tray (may vary by model). The cool pack will be at its most effective after it has been in the freezer for approximately 24 hours.
Switching the appliance OFF
^Press each ON/OFF button, so that the temperature display goes out.
The cooling process is now switched off. If this does not happen, then the safety lock is engaged.
12
