Changing the door hinging
^Pull off the cover g, and unscrew the hinge bracket h.
^Insert the pin i into the second hole of the hinge bracket h.
^Rotate the steel angle j and the cover k 180° each, then fit them on the opposite side.
^Screw the hinge bracket h on the opposite side. The M4 screw must be screwed into the left hole of the hinge bracket.
^Now rotate the cover g 180° and mount it on the opposite side.
^In the middle of the appliance, exchange the cover l and the bearing bracket m, as follows: Unscrew the cover l and the bearing bracket m, rotate them 180°, and screw them into place on the opposite side.
^Pull the bearing bushing n downward and out of the bearing bracket m, then
^Remove the plugs from the door bearing bushings at the top of the appliance doors, and fit them into place on the opposite side.
^Hang the upper appliance door on the pin i, and close the appliance door.
^Insert the middle bearing pin e through the bottom of the bearing bracket m in the upper appliance door.
^Check to see that the upper appliance door is properly aligned. Make any needed adjustments by using the length holes in the bearing bracket m.
^Hang the lower appliance door on the pin e, and close the appliance door.
^Insert the lower hinge bracket b in the door bearing bushing in the lower appliance door, and screw it completely onto the housing.
^Snap on the cover a.
44
