Miele KM5947, KM5956, KM5955, KM5948, KM5942, KM5958, KM5975 Safety instructions for installation

Safety instructions for installation

Fit wall units and extractor hood before fitting the hob to avoid damaging the surface.

~The veneer or laminate coatings of worktops (or adjacent kitchen units) must be treated with 100 °C heat-resistant adhesive which will not dissolve or distort.

Any backmoulds must be of heat-resistant material.

~This equipment may only be used in mobile installations such as ships, caravans, aircraft etc. if a risk assessment has been carried out by a suitably qualified engineer.

~The hob may not be built in over a fridge, fridge-freezer, freezer, dishwasher, washing machine or tumble dryer.

~These hobs must not be installed above ovens or cookers unless these have a built-in cooling down fan.

~After installing the hob, ensure that the connection cable cannot come into contact with the underside of the appliance. Make sure that there is no mechanical obstruction, such as a drawer, which could damage it.

~Observe carefully the safety distances given on the following pages.

~Do not use any sealant except where expressly instructed to do so. The seal underneath the appliance provides a sufficient seal for the worktop (See "General installation tips").

All dimensions in this instruction booklet are given in mm.

53